FREE SHIPPING OVER $30, ALL ORDERS SHIPPING FROM USA WAREHOUSE
Arduino Ethernet Rev3 WITHOUT PoE
Arduino Ethernet Rev3 WITHOUT PoE
Item Code: 82P-A000068



$55.50
Out of stock


The Arduino Ethernet is a microcontroller board based on the Arduino Uno, and incorporating a WizNet W5100 TCP/IP Embedded Ethernet Controller. It can be programmed like an Uno via a six-pin FTDI -style serial connector. The Arduino USB 2 Serial adapter or any FTDI-style USB-to-serial connector can be used to program it.

Additional features coming with the R3 version are:

  • pinout: added SDA and SCL pins for TWI communication placed near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board and the second one is a not connected pin, that is reserved for future purposes.
  • stronger RESET circuit.

A separate power-over-Ethernet (PoE) module can be soldered to the board to provide power from a conventional twisted pair Category 5 Ethernet cable. It is IEEE802.3af compliant, and works with all compliant PoE injectors currently available.

Technical Specifications


Microcontroller

ATmega328

Operating Voltage

5V

Input Voltage (recommended)

7-12V

Input Voltage (limits)

6-20V

Digital I/O Pins

14 (of which 4 provide PWM output)

Arduino Pins reserved
10 to 13 used for SPI
4 used for SD card
2 W5100 interrupt (when bridged)


Analog Input Pins

6

DC Current per I/O Pin

40 mA

DC Current for 3.3V Pin

50 mA

Flash Memory

32 KB (ATmega328) of which 0.5 KB used by bootloader

SRAM

2 KB (ATmega328)

EEPROM

1 KB (ATmega328)

Clock Speed

16 MHz

W5100 TCP/IP Embedded Ethernet Controller

 

Power Over Ethernet ready Magnetic Jack

 

Micro SD card, with active voltage translators