***Attention***The difference between the FlyFun-60A and FlyFun-60A-OPTO ESC***
Part # FlyFun-60A has built-in 5-Volt 3-Amp BEC*
Part # FlyFun-60A-OPTO does not have a built in BEC* an external power source for your receiver will be required
BEC = Battery Eliminator Circuit
1.1 Output:? Continuous 60A, Burst 80A up to 10 seconds.
1.2 Input Voltage:? 2-6 cells lithium battery or 5-18 cells NiCd/NiMh battery.???
FlyFun-60A: 3A / 5V switching mode BEC.
1.4 Refresh rate of the throttle signal: 50Hz to 432Hz.
1.5?Max Speed:? 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM.
(BLM = BrushLess Motor)
2.1 Safety arming feature:? Regardless the throttle stick position, the motor will not spin after battery connected.?
2.2?Throttle calibration funtion: Throttle range can be calibrated?to?be compatible with?different?transmitters.
2.3 User programmable.?
2.4 Multiple program methods?supported: transmitter stick,?LED Program Card.?Very easy to program the ESC at home or at the flying field.
2.5 Compatible with Lipo battery and NiCd/NiMH battery.
2.6 Internal timing can be changed to be suitable for different brushless motors.
2.7 Full protection: Low voltage cutoff protection / Over-heat protection / Throttle signal loss protection.
2.8 Extreme low resistance PCB is used at the power output section, the whole ESC has super current endurance capability.
2.9 Microprocessor uses separate voltage regulator IC, with good anti-jamming capability.