Raiden Outrunner Brushless Motor 400T 1100 RPM for RC Airplanes
Product Description
This is an awesome direct drive Motor. Dollar for Dollar about the best upgrade for the GWS war-birds I have seen. This motor is comparable to the Mega 16/15/7. Similar to the Aurora 400T, and the Motor Max (MTM) 400T. This is a type A motor. Meaning the shaft is removable, and can be flipped from a pusher to a puller application. No more press fitting a shaft or buying a new bell if your shaft breaks. Simply loosen the set screw and the shaft pulls out for easy replacement or mounting configuration changes. Made with high temp and high RPM bearings, high temp magnets good beyond 180 degrees. Recently re-worked to provide a closer tolerance shaft fit. Comes with 3.0mm shaft but 2.3mm is available on request.
The 400T comes with an "X" mount and screws (you will need connectors to the ESC). Fits in to any GWS type speed 400 gear box. And has fit every aluminum outrunner type mount we have tried so far. Mounting holes are 16mm (or roughly 5/8 in.)
All shafts are 3mm but we usually stock 2.3mm shafts if you prefer. With the 2.3mm shaft a pinion from a GWS 400 gear box will fit perfectly. Also no more press fitting a pinion and risk bending the shaft. Simply slide the pinion on and apply a dab of lock tight.
400T : Direct Drive
32 Turns ~ 1330kv ~ 12 amps
KV: 1330 Weight: 1.6oz (46g) Diameter: 26mm Length: 24mm Shaft: 3.0mm (2.3 avail.)
Direct Drive Stats (Factory Stats)
| Prop | Battery | Thrust oz. | Amps |
| 7 x 4 | 11.1v Lipo | 16 oz. | 10 Amps |
| 8 x 4 | 11.1v Lipo | 17 oz. | 8 Amps |
| 9 x 5 | 11.1v Lipo | 20 oz. | 11 Amps |
Direct Drive Stats (Stats by us at 4,907' above sea level)
| Prop | Volts | Thrust oz. | Amps | RPM | Pitch Speed MPH |
| No Load | 12.2 | - | 0.8 | 1330KV | - |
| No Load | 7.9 | - | 0.6 | 1330KV | - |
| 6 x 5.5 | 12.1 | 10 oz. | 9.2 Amps | Unknown | - |
| 7 x 5 | 12 | 16 oz. | 12 Amps | 12100 | 57 |
| 7 x 4 | 12.4 | 15 oz. | 10 Amps | Unknown | - |
| 8x6 | 12 | 18 oz. | 19 Amps | 8600 | 49 |
| 8 x 3.8 | 12 | 21 oz. | 15 Amps | 10900 | 39 |
Geared 2.4:1 Stats (obtained at 4907' feet)
| Prop | Volts | Thrust oz. | Amps | RPM | Pitch Speed MPH |
| 8 x 6 | 12 | 13 oz. | 5.8 Amps | 7050 | 40 |
| 9 x 3.8 | 12 | 14 oz. | 5 Amps | 7200 | 26 |
| 9 x 7.5 | 12 | 15 oz. | 8 Amps | 6600 | 47 |
| 10 x 3.8 | 12 | 20 oz. | 7.6 Amps | 6630 | 24 |
| 10 x 7 | 12 | 24 oz. | 11 Amps | 6100 | 40 |
| 11 x 7 | 12 | 28 oz. | 15 Amps | 5500 | 36 |
Tech Notes: This motor is conservatively rated at 12 amps. Folks flying at lower elevations with an 8x4 are peaking at 13.5 Amps. But here at almost a mile above sea level the air is thinner. To get the performance from our motors we usually have to prop up (increasing amp draw) or volt up (creating higher rpm's/amps). That being said keep in mind at lower elevations you will develop more thrust with little increase in amp draw. Fun little motor for planes to 20 oz.. Use on GWS type war birds and the ultrafly type parkflyers, others to 20oz.
Suggested Setup: 7x5, 8x3.8, 8x6, or 9x3.8. 8x4 or 7x5
Works Best with our Raiden 30A Brushless ESC - Overclockable to 40A MAX!!!!
